FIREBIRD Ink SKU: DTF-Sheet-14x16-100

DTF Sheets

5.0 / 5.0 based on 1 review

$85.00 $100.00 Save $15

Available Now!

Size: 14" x 16"
Count: 100 Sheets

Legendary FIREBIRD Support Included
Our DTF Masters are ready to help you optimize!

100% Satisfaction Guaranteed
Or your money-back, within 30-days of purchase.

Exceptional Peeling Ease

Say goodbye to the struggles with peeling. FIREBIRD Ink DTF transfer sheets revolutionize your printing process with effortless peeling. Peel confidently and quickly, without the risk of damaging your masterpieces.

No More Powder-Sticking

FIREBIRD Ink recognizes the necessity of immaculate, sharp images. That's why our DTF sheets are meticulously designed to prevent powder-sticking. Cast away worries about unwanted powder residues that tamper with your image quality. Our DTF sheets ensure a clean, precise transfer, upholding the integrity of your designs and keeping the spotlight on your striking images.

 

Print onto DTF Transfer Film

  1. Load the transfer sheet onto printer-platen, with the matte side facing up. Tip: Always handle film by edges or corners.
  2. Print according to ink manufacturer's recommendations, or rip profile settings.
  3. Remove from platen and prepare for powder application.
  4. If recommended by your ink manufacturer, let the ink sit for at least 1 minute or hover press for 15 seconds, before adding powder.

Apply DTF Powder

  1. Add powder evenly across one end of the printed side of the film.
  2. Lift and allow powder to slowly and evenly slide across the entire sheet.
  3. Gently shake and tap the film from the back, to remove any excess powder.

Note: Our films release the excess powder very easily, so you don't have to shake the film excessively.

Cure Powder onto Printed Film

  1. Cure according to your powder manufacturer's instructions.
    • If using FIREBIRD DTF Powdercure at 300°F for 60-90 seconds on an IR conveyor, or use a heat-press to hover-cure for 4-5 minutes at 340°F.

Apply Finished DTF Transfer to Garment

  1. Place cured film with printed-side down onto your garment.
  2. Heat-press the film onto garment as follows:
    • 100% Cotton or Cotton-Blend: Light to medium pressure for 8-10 seconds at 300-320°F.
    • 100% Polyester: Light to medium pressure for 10-15 seconds at 280°F.
    • Optional: Press again for 5-10 seconds with teflon or parchment sheet cover.
  3. Remove garment from heat-press platen.
  4. Allow transfer to slightly cool down before peeling film, or let sit for cold-peel application.

Note: For long-term storage of finished DTF Transfer sheets, it is best to keep them away from heat and humidity.

Customer Reviews

Based on 1 review Write a review